JP3 Motorsports FC3S Fire Extinguisher Mount Install
Time Investment: 1 HourDifficulty: Low
Tools Used:
10mm, 12mm, 14mm Socket
10mm, 12mm Wrench
Ratchet
Socket Extension
4mm Allen Wrench
Information:
- Removing the bolts that mount the seat to the chassis is a lot easier with an Impact
- I utilized the H3R Quick Release Bracket which used M5 allen bolts instead of the JP3 provided M6
Steps:
1. Slide the seat all the way back and remove the two bolts holding the front of the seat to the chassis with a 14mm socket and ratchet
2. Slight the seat all the way forward and remove the two bolts holding the rear of the seat to the chassis with a 14mm socket and ratchet
3. Remove the seat fully from the car and slide the rails back as far as they can go; Remove the top two 12mm bolts with a 12mm socket and ratchet and the right one with a wrench (ignore the bracket in the picture, I forgot to take a picture without it)
4. Slide the JP3 Fire Extinguisher mounting bracket behind the rails and re-secure them using the 12m socket, ratchet and the 12mm wrench
5. Attach the additional JP3 secondary bracket utilizing the JP3 provided longer allen head M6s, washer, and nut (hand tight)
6. Re-install the seat into the car utilizing the 14mm socket and ratchet
7. Fully extend the JP3 secondary bracket and tighten down the allen bolts utilizing the 4mm allen wrench and a 10mm socket and ratchet
8. Install the Fire Extinguisher Holder to the JP3 secondary bracket utilizing the 4mm allen wrench and 10mm socket
9. Install your H3R Fire Extinguisher